Front Turn Signal LEDs for 1984-1996 Nissan 300ZX (pair)

As low as $40.00
In stock
Only %1 left
SKU
diod-frnturn-3617
Front Turn Signal LEDs for 1984-1996 Nissan 300ZX (pair) is available to buy in increments of 1

Specifications

Operating Voltage: 9-16V
Connector(s): OEM-Size Plug and Play
Bulb Size: 1156
Application: Front Turn Signal
Make: Nissan
Model: 300ZX
Years: 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996
Flasher Setup: Replaceable Relay, CF15

What's Included

100% Satisfaction Guarantee

Features

  • Modern LED appearance with instant on and off
  • Direct replacement for Nissan 300ZX front turn bulbs
  • Plug and play, no modification with factory 1156 bulb size
  • Multiple brightness levels available

Overview

LED Indicators. The factory incandescent turn signals on the Nissan 300ZX illuminate in a slow glow, taking a moment to turn off and on. With replacement LED bulbs, you can immediately update your vehicle with the instant on-off blinking of modern LEDs. This instant activation adds a modern and distinct look to the 300ZX.

Dual Brightness. The 300ZX uses a 1156 dual-filament bulb. They light up with low power as parking lights, then they get brighter when the turn signal or hazards are activated. The brightness ratio of your factory bulbs is traditionally 15:100, or 15% lumen output for the dim function. Diode Dynamics bulbs are designed to match this, so there is enough distinction between "low" and "high" brightness levels. As with all Diode Dynamics LED bulbs, these turn signal bulbs are rated with accurate, measured lumen figures, not calculations or guesses.

Reduced Load. When it comes to LED upgrades, you'd think the lower power draw would be a great feature! However, the 300ZX looks for a specific power draw from the turn signals. LEDs will make the vehicle think a bulb has gone out, due to lower power draw. This causes a "hyperblink," or fast-blinking turn signal, which can be corrected with LED Resistors or an LED Flasher.

The most basic, tried-and-true method to correct hyperblinking is to add resistors. These can be used on any vehicle, because a 6-ohm resistor uses about the same power as a standard turn signal bulb. One resistor is needed to replace each turn signal bulb.

You may have also heard of flasher relays, which is the actual module that determines flash speed. On some vehicles, it can be replaced with one that is designed for LED power levels. However, on many newer vehicles these modules cannot be replaced. If it's possible to replace the flasher on the 300ZX, you'll see one listed above. Only one flasher is needed per vehicle, for both front and rear LED turn signal conversions.

Reliability. Diode Dynamics LEDs are built with constant-current inductive circuitry, along with transient suppression. They are tested by our engineering team with a device that replicates years of voltage spikes, like the ones generated each time the alternator starts and stops on your 300ZX. This is what kills most LED bulbs over time, but just like factory components, Diode Dynamics LEDs are designed with built-in circuit protection. While more expensive than simple bulbs, this allows Diode Dynamics LEDs to last for years, with no flickering or failure.

Experience. After over a decade in business, Diode Dynamics is one of the most trusted names in automotive LED lighting. We directly assemble and engineer an increasing number of products in the United States, allowing for higher quality and performance, with the newest and brightest LED technology. Whether it's a Nissan or anything else, we pride ourselves in offering only the best possible LED solutions. Please contact us if you'd like to discuss your lighting project!

Bulb Options

1156 HP48 -

  • 48 LEDs in omnidirectional design.
  • Diffusing cover for even output and clean appearance when off.
  • Metal base connector with full-spec positive connection terminal.
  • Cosmetic upgrade only.
  • 250 lumens per bulb.

1156 HP11 -

  • Four COB type LED with a single high-power chip mounted at top.
  • Full metal heatsinking for reliable operation.
  • Nonpolar and CK compatible electrical design.
  • 310 lumens per bulb.

1156 XP80 -

  • Sixteen high-power 5W LEDs arranged in all directions.
  • Metal heatsink to maintain high output.
  • Constant current, inductive drive circuit.
  • 510 lumens per bulb.

What's Included

Quantity: Two (2)
Warranty: 3 year warranty
Return Policy: 30-day Return with no restocking fee
100% Satisfaction Guarantee

Fitment

NOTE: Please check your factory bulb size before ordering, as some models may use a different size bulb. If your vehicle uses an 1157 bulb, .

Bulb Size: 1156
Application: Front Turn Signal
Make: Nissan
Model: 300ZX
Years: 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996
Flasher Setup: Replaceable Relay, CF15

More Information

More Information
Length 3in

Reviews

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account