Umnitza Luxen BiLED Projector Retrofit Single and Dual Core 2.5" (Bi-LED)

Umnitza Luxen Bi-LED Projectors - Single and Dual Core

Our new H1 Luxen Bi-LED Projectors allows you to swap into almost any housing - H1, 900X, H4, H7, and even some D2S and D1S. It's threaded shaft allows easy install without major modifications.   It simply fits inside, no need for grommets, relays, clunky wiring, no additional ballasts or bulbs. Everything fits inside the housing, making your headlight builds completely waterproof and free of outside debris.  This is a single core Bi-LED projector and dual core as an option like others on the market but has one of the widest and best patterns with a dense light throughout the range - very similar to the NHK Gen IV but for 20-30% less cost.  However, since they are fan cooled, you should allow some room from the back of the housing the back of the projector fan base.

How does it stack up compared to HID?

HID Projectors are $120-200, HID quality ballasts are $120-150 with quality bulbs, and in some cases, you'll need a relay harness and other parts.  This is just mount and go. AND you don't have to worry about longevity or a bulb burning out. it's rated for 50000 hours.

Mounting:

This projector is similar to the mounting pattern of other 2.5" threaded projectors like the Morimoto Mini H1 and other H1s, it's perfect for use in nearly every JDM/USDM application.

POWER

Maximum flexibilty for wiring with 2 LOW BEAM Polarity Wires (RED/BLACK), and 2 High beam Polarity (BLACK/RED).  You can use H7, 9006, etc adaptesr or just splice, solder, or wire nut them tight inside the housing.