Orion V2 LED Angel Eyes for Acura TL (08-09)

$139.99
In stock
SKU
ae-v2TL08
Orion V2 LED Angel Eyes for Acura TL (08-09) is available to buy in increments of 1
Orion V2 LED Angel Eyes for Acura TL (08-09)

Title:

Acura TL Orion V2 LED Angel Eyes

Application (Please consult your owner's manual for your application fitment type):

ALL Acura TL 08+

Product Description (may describe some optional equipment) :

  • 2 V2 Angel Eye Rings

  • 1 full wiring harness

  • Lifetime Warranty

  • Online Instructions

  • All Hardware and Installation Included

Engineering Detail:

  • Requires baking of the headlights (20 minutes @ 200 degrees on cookie sheet and bake)

  • 30-50 minute complete install using standard hand tools per side.

  • 50000mcd or 3X as bright as the nearest competitor.

Benefits:

  • Updated Look

  • Allows you to clear or black out your turn signal at the same time

  • Can be wired as DRL (daytime running lights)

  • Significant improvement in visual appeal of car

 

Install Tips:

  • PRETEST the bulbs, do not flex the bulbs in any way.

  • Mount the controller UNDER the radiator support on a flat, dry and vibration free surface

  • Ensure secure connections to and from the headlight.

Additional information links:

VIDEO http://www.youtube.com/watch?v=U1C5VJtetN8

The video is provided without any express or implied approval of the techniques described in the video. Any information contained in the video has not been provided or approved by Umnitza. Viewer or Installer assumes all risks when following the advice set forth in the youtube video above.

Install Tips:

  • PRETEST the bulbs, do not flex the bulbs in any way.

  • Mount the controller UNDER the headlights on a flat, dry and vibration free surface

  • Ensure secure connections to and from the headlight.

1) Remove bolt from fender liner in the wheel well.
2) Remove bolt holding bumper edge just inside peeled back fender liner.
3) Remove all the bolts at the bottom of the bumper
4) Remove 5 pins from the top of the bumper
5) remove bumper.
6) Remove fender bolts holding lights
7) Remove top 2 bolts holding lights
8) Disconnect as many connections as possible prior to...
9) Pulling light out
10) Cookie sheet for 20 minutes at 200 degrees
11) Remove 4 screws holding back of light against front of light plexiglass, gently slide plastic tabs off the front plexiglass while doing this.

12) Remove inner beauty trim's 2 screws.

13) Place rings at respect corners - 1 dap of glue - less than an teardrop worth at the corners of the rings and the bottom of the ring center.
14) Insert ring bottom FIRST, then push gently tops of rings onto beveled edge of trim piece.
15) Hold for 2-3 minutes (use QUICKGRIP for best results)
16) Wait 10 minutes for glue to fully set.
17) Push wires out the back of high beam and low beams respectively, remove the rubber caps frist, then seal rubber caps OVER the wires.
18) Put back into oven for 5 minutes, seal up headlight and re-insert all screws.
19) Attach black connectors.
20) Finish Install by reattaching all body parts.

21) YOU ARE DONE SEE LINK BELOW FOR ADDITIONAL PICS

 

See This Link for Detailed Pictures


Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account